Reassembly

PARKING BRAKE: PARKING BRAKE ASSEMBLY: REASSEMBLY

REASSEMBLY

1. INSPECT PARKING BRAKE SHOE LINING THICKNESS






(a) Using a ruler, measure the thickness of the shoe lining.
Standard thickness:
4.0 mm (0.158 in.)
Minimum thickness:
1.0 mm (0.0394 in.)
If the lining thickness is at the minimum thickness or less, or if there is severe or uneven wear, replace the brake shoe.
2. INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT






(a) Apply chalk to the inside surface of the disc, then grind down the brake shoe lining to fit.
If the contact between the brake disc and the shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe assembly.
3. APPLY HIGH TEMPERATURE GREASE
(a) Apply the high temperature grease to the shoe attached surface of backing plate Components.
4. INSTALL PARKING BRAKE SHOE
(a) Install the shoe lever and the shim to the rear shoe with a new C-washer.






(b) Using a feeler gauge, measure the clearance.
Standard clearance:
Less than 0.25 mm (0.00984 in.)
If the clearance is not within the specification, replace the shim with one of the correct size.










(c) Apply the high temperature grease to the adjusting bolt and piece.
(d) Install the shoe adjusting screw set and the tension spring to the front and rear shoe.
(e) Install the 2 pins, 4 cups and 2 shoe hold-down springs.
(f) Connect the parking brake cable to the shoe lever.
(g) Install the front and rear parking brake shoe.
5. INSTALL PARKING BRAKE SHOE STRUT LH
6. INSTALL PARKING BRAKE SHOE STRUT COMPRESSION SPRING
7. INSTALL PARKING BRAKE SHOE RETURN TENSION SPRING






(a) Using a needle nose pliers, install the 2 return tension springs.
HINT: Install front side spring first, rear side spring next.

8. CHECK PARKING BRAKE INSTALLATION
(a) Check that each part is installed properly.
NOTE: There should be no oil or grease adhering to the friction surface of the shoe lining and disc.





9. INSTALL REAR DISC
10. ADJUST PARKING BRAKE SHOE CLEARANCE






(a) Temporarily install the hub nuts.
(b) Remove the hole plug, and turn the adjuster and expand the shoes until the disc locks.
(c) Contract the shoe adjuster until the disc rotates smoothly.
Standard :
Return 8 notches
(d) Check the shoe has no brake drag.
(e) Install the hoke plug.
11. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
(a) Install the rear disc brake caliper with the 2 bolts.
Torque: 105 Nm (1071 kgf-cm, 77 ft-lbf)
12. INSTALL REAR WHEEL
Torque: 112 Nm (1137 kgf-cm, 82 ft-lbf)
13. INSPECT PARKING BRAKE LEVER TRAVEL Adjustments

14. ADJUST PARKING BRAKE LEVER TRAVEL Adjustments