C0226

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM: C0226/21: SFR Solenoid Circuit

DTC C0226/21 - SFR Solenoid Circuit

DTC C0236/22 - SFL Solenoid Circuit

DTC C0246/23 - SRR Solenoid Circuit

DTC C0256/24 - SRL Solenoid Circuit

DTC C1225/25 - SM Solenoid Circuit

DESCRIPTION

These solenoids turn on when signals are received from the skid control ECU and they control the pressure acting on the wheel cylinders to control the braking force.






WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. RECONFIRM DTC
HINT: These codes are detected when a problem is determined in the brake actuator assembly.
The solenoid circuit is in the brake actuator assembly.
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC is output before replacing the brake actuator assembly.
(a) Clear the DTCs .
(b) Turn the ignition switch to the ON position.
(c) Check if the same DTCs are recorded .
Result:





NOTE: When replacing the brake actuator assembly, perform zero point calibration. Calibration

B -- END
A -- REPLACE BRAKE ACTUATOR ASSEMBLY