Door Lock Position Circuit

LIGHTING SYSTEM: Door LOCK Position Circuit

Door LOCK Position Circuit

DESCRIPTION

This circuit detects the state of the door lock detection switch and send it to the multiplex network body ECU.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING INTELLIGENT TESTER
(a) Connect the intelligent tester to the DLC3.
(b) Turn the ignition switch to the ON position and press the intelligent tester main switch ON.
(c) Select the items below in the DATA LIST, and read the displays on the intelligent tester.

BODY





NG -- INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
2. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY





(a) Measure the voltage according to the value(s) in the table below.
Voltage:





(b) Measure the voltage according to the value(s) in the table below.





Voltage:










(c) *1: Oscilloscope wave
- Gauge set: 5 V/DIV. 5 ms/DIV
- Condition: Ignition switch ON

NG -- GO TO POWER DOOR LOCK CONTROL SYSTEM
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE