B2797

ENGINE IMMOBILIZER: ENGINE IMMOBILIZER SYSTEM: B2797: Communication Malfunction No. 1

DTC B2797 - Communication Malfunction No. 1

DESCRIPTION

This DTC is output when an error occurs in normal communication.
HINT: Some noise is found in the communication line.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK KEY




(a) Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether the key ring is in contact with the key grip.






B -- CHECK TRANSPONDER KEY AMPLIFIER
A -- Continue to next step.
2. CHECK DTC OUTPUT
(a) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.
(b) Insert the key into the ignition key cylinder.
(c) Check that no code is output.
OK:
No DTC is output.
OK -- END
NG -- Continue to next step.
3. CHECK TRANSPONDER KEY AMPLIFIER




(a) Using an oscilloscope, check the waveform between the terminals of the I17 amplifier and T9 ECU connectors.
(b) Check that no noise is included in the waveform (an example of noise is shown on the left).
Result:










NG -- FIND CAUSE OF NOISE AND REMOVE IT
OK -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)




(a) Disconnect the T9 ECU and I17 amplifier connectors.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. CHECK TRANSPONDER KEY AMPLIFIER
(a) After replacing the transponder key amplifier with a normally functioning transponder key amplifier Removal, check that the engine starts.
OK:
The engine starts.
NG -- REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK -- END