P0630

2UZ-FE ENGINE CONTROL SYSTEM: SFI SYSTEM: P0630: VIN not Programmed or Mismatch - ECM / PCM

DTC P0630 - VIN not Programmed or Mismatch - ECM / PCM

DESCRIPTION

DTC P0630 is set if the Vehicle Identification Number (VIN) is not stored in the ECM or the input VIN is not accurate. Input the VIN with the Techstream.






MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS





TYPICAL MALFUNCTION THRESHOLDS





COMPONENT OPERATING RANGE





INSPECTION PROCEDURE

PROCEDURE

1. READ CURRENT DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch ON and turn the tester ON.
(c) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
(d) Read the DTCs.
Result:





- If any DTCs other than P0630 are output, troubleshoot those DTCs first.
NOTE:
If P0630 is set, the VIN must be input to the ECM using the Techstream. However, all DTCs are cleared automatically by the tester when inputting the VIN. If DTCs other than P0630 are set, check them first.

B -- GO TO DTC CHART
A -- Continue to next step.
2. INPUT VIN WITH TECHSTREAM
(a) Input the VIN with the Techstream Programming and Relearning.
NEXT -- END