U0208

NETWORKING: CAN COMMUNICATION SYSTEM: U0208: Lost Communication with "Seat Control Module A"

DTC U0208 - Lost Communication with "Seat Control Module A"

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(a) Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
- W/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

NEXT -- Continue to next step.
2. CHECK FOR OPEN IN CAN BUS WIRE (POSITION CONTROL ECU AND SWITCH BRANCH WIRE)

(a) Disconnect the c15 position control ECU and switch connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:

NG -- REPAIR OR REPLACE POSITION CONTROL ECU AND SWITCH BRANCH WIRE OR CONNECTOR (MPX1, MPX2)
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (POSITION CONTROL ECU AND SWITCH - BATTERY AND BODY GROUND)
(a) Connect the cable to the negative (-) battery terminal.
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

(b) Disconnect the c14 position control ECU and switch connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:

(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE POSITION CONTROL ECU AND SWITCH ASSEMBLY