B1412

HEATING / AIR CONDITIONING: AIR CONDITIONING SYSTEM: B1412/12: Ambient Temperature Sensor Circuit
B1412/12 - Ambient Temperature Sensor Circuit

DESCRIPTION

The ambient temperature sensor is installed in the front part of the condenser to detect the ambient temperature and control the air conditioner auto mode. The sensor connected to the air conditioning amplifier assembly detects fluctuations in the ambient temperature. This data is used for controlling the room temperature. The sensor sends a signal to the air conditioning amplifier assembly. The resistance of the ambient temperature sensor changes in accordance with the ambient temperature. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.

The air conditioning amplifier assembly applies voltage (5 V) to the ambient temperature sensor and reads voltage changes as the resistance of the ambient temperature sensor changes.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM (AMBIENT TEMPERATURE SENSOR)

(a) Use the Data List to check if the ambient temperature sensor is functioning properly.

Air Conditioner





OK:

The display is as specified in the normal condition.

NG -- INSPECT AMBIENT TEMPERATURE SENSOR

OK -- REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY Removal

2. INSPECT AMBIENT TEMPERATURE SENSOR





(a) Remove the ambient temperature sensor Removal.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NOTICE:
* Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
* When measuring, the sensor temperature must be the same as the ambient temperature.

HINT
As the temperature increases, the resistance decreases (See the graph).

NG -- REPLACE AMBIENT TEMPERATURE SENSOR Removal
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (AMBIENT TEMPERATURE SENSOR - AIR CONDITIONING AMPLIFIER)





(a) Disconnect the A14 sensor connector.

(b) Disconnect the E35 amplifier connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY Removal