Smart Access System With Push-Button Start (for Start Function)
THEFT DETERRENT / KEYLESS ENTRY: SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Start Function): CUSTOMIZE PARAMETERS
1. CUSTOMIZE SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Start Function)
HINT
The following items can be customized.
NOTICE:
* When the customer requests a change in a function, first make sure that the function can be customized.
* Record the current settings before customizing.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the engine switch on (IG).
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Smart Access or Warning.
(5) Select the setting by referring to the table below.
(b) Customizing with Multi-display
(1) Turn the engine switch on (IG).
(2) Select the following menus: Setup / Vehicle / Vehicle Customizing.
(3) Select the setting by referring to the table below.
(c) Customizing with Multi-information display
(1) Turn the engine switch on (IG).
(2) With the vehicle stationary or at a vehicle speed of less than 8 km/h (4.9 mph), press and hold the menu switch on the steering pad switch to display the meter customize mode screen.
(3) Select the setting by referring to the table below.
(d) Entry cancel function
HINT
While the smart access system with push-button start is canceled, it is possible to lock and unlock the doors with the wireless operation, and the start system can be operated by holding the key against the engine switch.
(1) The following functions are disabled when the smart access system with push-button start is canceled.
Entry unlock/lock functions
Entry ignition function
Key lock-in prevention function
Entry glass hatch open function
Entry warning functions
(2) When using the multi-display:
Cancel the smart access system with push-button start (see above).
(3) When using the multi-information display in the combination meter assembly:
Cancel the smart access system with push-button start (see above).
(4) When canceling the system through manual operation:
Make sure the following conditions are met:
* The engine switch is off.
* The driver side door is closed.
* The driver side door is unlocked.
Press the unlock button of the key.
Open the driver side door within 5 seconds of completing the step above (driver side door: closed at beginning of step -> opened).
With the driver side door open, press the unlock button of the key 2 times within 5 seconds of completing the step above.
NOTICE:
If the driver side door is closed before or while pressing the unlock button, the entry cancel setting mode will end.
Close and open the driver side door twice within 30 seconds of completing the above step (driver side door: open at beginning of step -> closed -> opened -> closed -> opened).
With the driver side door open, press the unlock button of the key 2 times within 30 seconds of completing the step above.
Close and open the driver side door within 30 seconds of completing the step above (driver side door: open at beginning of step -> closed -> opened).
Close the driver side door within 5 seconds of completing the above step.
Check that the wireless buzzer sounds twice (short beeps) to confirm that the smart access system with push-button start has been canceled.
(5) Perform the following procedure to restore the smart access system with push-button start to the active state from the canceled state.
Perform the procedures to cancel the smart access system with push-button start again.
Check that the wireless buzzer sounds once (short beep) to confirm that the smart access system with push-button start has been restored to the active state.
HINT
* The system changes between the canceled state and the active state each time the procedure to cancel the system through manual operation is performed.
* The buzzer sounds twice when the system changes from the active state to the canceled state, and sounds once when the system changes from the canceled state to the active state.