Removal

HEATING / AIR CONDITIONING: COMPRESSOR: REMOVAL

1. PRECAUTION

CAUTION:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Service Precautions.

2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM Service and Repair

3. REMOVE REAR DECK FLOOR BOX Removal

4. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. REMOVE BATTERY SERVICE HOLE COVER Removal

6. REMOVE SERVICE PLUG GRIP Removal

7. REMOVE RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR

HINT
Refer to the procedure for Remove No. 2 Radiator Assembly Removal.

8. CHECK TERMINAL VOLTAGE

(a) Remove the inverter terminal cover Removal.

(b) Check the terminal voltage Removal.

(c) Install the inverter terminal cover Installation.

9. DISCONNECT SUCTION HOSE SUB-ASSEMBLY

(a) Release the green-colored lock and disconnect the connector [A] as shown in the illustration.





Text in Illustration





CAUTION:
Wear insulated gloves.

NOTICE:
Insulate the connector by sealing it with tape.

(b) Disconnect each connector [B], [C].

(c) Disengage each clamp.

(d) Remove the bolt.





(e) Disengage the clamp and disconnect the suction hose sub-assembly from the electric inverter compressor assembly.

(f) Remove the O-ring from the suction hose sub-assembly.

NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

10. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

(a) Remove the bolt and disconnect the discharge hose sub-assembly from the electric inverter compressor assembly.





(b) Remove the O-ring from the discharge hose sub-assembly.

NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

11. REMOVE ELECTRIC INVERTER COMPRESSOR ASSEMBLY

(a) Remove the 3 bolts, bracket and electric inverter compressor assembly.





Text in Illustration





(b) Remove the bolt and bracket from the electric inverter compressor assembly.