P060A

2UR-GSE ENGINE CONTROL: SFI SYSTEM: P060A: Internal Control Module Monitoring Processor Performance

DTC P060A - Internal Control Module Monitoring Processor Performance

MONITOR DESCRIPTION

The main CPU and sub CPU of the ECM perform data communication between each other. The main CPU monitors the communications and WDC pulses from the sub CPU. When the malfunction below is detected, the DTC is stored.






MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS





TYPICAL MALFUNCTION THRESHOLDS





INSPECTION PROCEDURE

PROCEDURE

1. READ OUTPUT DTC (DTC P060A)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream ON.
(d) Clear DTCs DTC Check / Clear.
(e) Turn the engine switch to off and turn the Techstream off.
(f) Disconnect the Techstream.
(g) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
(h) Connect the cable to the negative (-) battery terminal.
(i) Connect the Techstream to the DLC3.
(j) Turn the engine switch on (IG).
(k) Turn the Techstream ON.
(l) Enter the following menus: Powertrain / Engine / Trouble Codes.
(m) Read the DTCs.
Result:






B -- REPLACE ECM
A -- CHECK FOR INTERMITTENT PROBLEMS