Pinout Values and Diagnostic Parameters

MIRROR (EXT): POWER MIRROR CONTROL SYSTEM: TERMINALS OF ECU

MIRROR

1. CHECK OUTER MIRROR CONTROL ECU LH





(a) Disconnect the M10 connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:





If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





If the result is not as specified, there may be a malfunction on the wire harness side.
(d) Reconnect the M10 connector.
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage:






2. CHECK OUTER MIRROR CONTROL ECU RH





(a) Disconnect the L10 connector.
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:





If the result is not as specified, there may be a malfunction on the wire harness side.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:





If the result is not as specified, there may be a malfunction on the wire harness side.
(d) Reconnect the L10 connector.
(e) Measure the voltage according to the value(s) in the table below.
Standard Voltage: