P060E

2UR-GSE ENGINE CONTROL: SFI SYSTEM: P060E: Internal Control Module Throttle Position Performance

DTC P060E - Internal Control Module Throttle Position Performance

MONITOR DESCRIPTION

The ECM monitors the signals of the throttle position sensor No. 1 and stop light switch. As the ECM monitors the input signals of the throttle position sensor No. 1 and the STP signals of the stop light switch, if the input signals and control signals are deviated, the DTC is output.






MONITOR STRATEGY





TYPICAL ENABLING CONDITIONS





TYPICAL MALFUNCTION THRESHOLDS





INSPECTION PROCEDURE

PROCEDURE

1. READ OUTPUT DTC (DTC P060E)
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream ON.
(d) Clear DTCs DTC Check / Clear.
(e) Turn the engine switch to off and turn the Techstream off.
(f) Disconnect the Techstream.
(g) Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
(h) Connect the cable to the negative (-) battery terminal.
(i) Connect the Techstream to the DLC3.
(j) Turn the engine switch on (IG).
(k) Turn the Techstream ON.
(l) Enter the following menus: Powertrain / Engine / Trouble Codes.
(m) Read the DTCs.
Result:






B -- REPLACE ECM
A -- CHECK FOR INTERMITTENT PROBLEMS