Brake Lamp Relay: Testing and Inspection

LIGHTING (EXT): STOP LIGHT CONTROL RELAY: INSPECTION

1. INSPECT STOP LIGHT CONTROL RELAY

(a) Disconnect the J96 stop light control relay connector.





(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





(b) If the result is not as specified, there is a malfunction on the wire harness side.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





(c) If the result is not as specified, there is a malfunction on the wire harness side.

(d) Reconnect the J96 stop light control relay connector.





(e) Measure the voltage according to the value(s) in the table below.

Standard Voltage:





(e) If the result is not as specified, replace the stop light control relay.