Removal

BRAKE CONTROL: SKID CONTROL BUZZER: REMOVAL

NOTICE:
While the battery is connected, even if the power switch is OFF, the brake control system activates when the brake pedal is depressed or the door courtesy switch turns on. Therefore during servicing of the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal

2. REMOVE BATTERY SERVICE HOLE COVER LH Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

(a) Disable the AUTO TILT AWAY function by changing the customize parameter Repair Instruction - Customize Parameters.

NOTICE:
Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.

(b) Turn the power switch ON (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.

(c) Turn the power switch OFF and disconnect the cable from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* w/ Navigation System (for HDD):
* After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal

5. REMOVE INSTRUMENT SIDE PANEL LH Removal

6. REMOVE NO. 1 INSTRUMENT CLUSTER MOULDING Removal

7. REMOVE STEERING COLUMN COVER (w/o Driver Monitor Camera) Removal

8. REMOVE STEERING COLUMN COVER (w/ Driver Monitor Camera) Removal

9. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY Removal

10. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal

11. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal

12. REMOVE SKID CONTROL BUZZER ASSEMBLY

NOTICE:
If the buzzer connector is disconnected with the buzzer installed to the vehicle, the clamp of the buzzer may be damaged. Make sure to remove the buzzer according to the procedures below.

(a) Detach the clamp and disconnect the buzzer from the extension panel.





(b) Disconnect the connector and remove the buzzer.