Installation

POWER STEERING: VANE PUMP: INSTALLATION

1. INSTALL VANE PUMP ASSEMBLY

(a) Install the power steering vane pump with the nut.

Torque : 43 Nm (440 kgf-cm, 32 ft-lbf)

(b) Install the 2 bolts.

Torque : 39 Nm (400 kgf-cm, 29 ft-lbf)

(c) Install the pressure feed tube and a new gasket to the pressure feed hose union bolt.





HINT
Make sure the stopper of the pressure feed tube touches the power steering vane pump body as shown in the illustration, then torque the union bolt.

Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)

(d) Connect the return hose with the clip.

(e) Connect the 2 vacuum hoses with the 2 clips.

2. INSTALL FAN & GENERATOR V BELT





(a) Put a wrench on the drive belt tensioner set bolt.

(b) Turn the drive belt tensioner set bolt counterclockwise and hold it.

HINT
The drive belt tensioner set bolt has a left-hand thread. The drive belt tensioner set bolt loosens when it is turned clockwise.

(c) Install the fan and generator V belt.





(d) Release the drive belt tensioner.

HINT
The drive belt tensioner is an auto tensioner.

3. INSTALL AIR CLEANER ASSEMBLY

(a) Install the air cleaner with the 3 bolts.

(b) Install the clamp.

(c) Connect the MAF meter connector.

4. INSTALL NO. 1 AIR CLEANER INLET

(a) Install the air cleaner inlet with the bolt.

5. INSTALL ENGINE UNDER COVER REAR RH

(a) Install the under cover with the 2 bolts.

6. INSTALL ENGINE UNDER COVER

(a) Install the under cover with the 16 bolts.

7. BLEED AIR FROM POWER STEERING SYSTEM Power Steering System

8. INSPECT POWER STEERING FLUID LEAK