Rear Vanity Light Does Not Illuminate

LIGHTING: LIGHTING SYSTEM: Rear Vanity Light does not Illuminate
- Rear Vanity Light does not Illuminate

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (MAP LIGHT - BATTERY)





(a) Disconnect the X4 light connectors.

(b) Measure the voltage according to the value(s) in the table below.

Standard voltage:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. CHECK HARNESS AND CONNECTOR (MAP LIGHT - REAR VANITY LIGHT)





(a) Disconnect the X4, X6, X11 (for LH) and X14 (for RH) light connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

for LH
for RH










NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

3. CHECK REAR VANITY LIGHT ASSEMBLY (OPERATION)

(a) Check that the malfunction disappears when the rear vanity light is replaced with a normal one Removal.

OK:

Malfunction disappears

NG -- REPLACE MAP LIGHT ASSEMBLY Removal

OK -- END (REPLACE REAR VANITY LIGHT ASSEMBLY) Removal