Interior Rear View Mirror

Interior Rear View Mirror













Removal

NOTICE: The windshield must be at room temperature. Otherwise, damage to the windshield glass may occur.

1. Disconnect the electrical connector.

2. If equipped, remove the compass module.

3. Position the interior rear view mirror to the full downward position.

4. NOTICE: Make sure the Mirror Remover is fully inserted into the interior rear view mirror mount access hole. Otherwise, damage to the windshield glass may occur.

Insert the Mirror Remover between the interior rear view mirror mount and windshield bracket, located at the top of the interior rear view mirror mount.





5. NOTICE: Twisting the interior rear view mirror mount from right to left may cause a stress fracture to the windshield.

NOTICE: Make sure to use the windshield bracket as the pivot point. Otherwise, damage to the windshield will occur.

Release the interior rear view mirror mount from the windshield bracket by pulling the Mirror Remover downward and away from the windshield.





Installation

1. Slide the interior rear view mirror mount over the windshield bracket from the top.





2. Press the interior rear view mirror mount downward along the windshield bracket until a click is felt. The click indicates that the mirror mount is engaged onto the windshield bracket.

3. If equipped, Install the compass module.

4. Connect the electrical connector.

5. If equipped, check the compass zone and calibration. For additional information, refer to Electronic Compass Adjustments.