Parking Assist Control Module: Service and Repair

Parking Aid Module (PAM)

NOTE: 4-channel shown, 8-channel similar











Removal and Installation

1. NOTE: Module configuration is only required if a new Parking Aid Module (PAM) is being installed.

Upload the PAM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Module Configuration Programmable Module Installation (PMI).

2. Remove the parcel shelf trim panel. For additional information, refer to Interior Trim and Ornamentation Service and Repair.

3. Disconnect the PAM electrical connector.

4. Remove the 2 screw-type retainers and the PAM.

5. To install, reverse the removal procedure.
- Download the PAM configuration information. For additional information, refer to Module Configuration Programmable Module Installation (PMI).