Clutch Pedal Assembly: Service and Repair

CLUTCH PEDAL REMOVAL/INSTALLATION

CAUTION:
- Fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. If it is spilled, wipe it off immediately.

1. Remove the battery cover. Removal and Replacement Removal and Replacement

2. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement

3. Remove the battery component. (ex: battery, battery tray and PCM component) Removal and Replacement Removal and Replacement

4. Separate the steering shaft. Steering Wheel And Column Removal/Installation - Without Advanced Keyless Entry And Push Button Start System Steering Wheel And Column Removal/Installation - With Advanced Keyless Entry And Push Button Start System

5. Separate the clutch pipe and reserve hose. Service and Repair

6. Remove in the order indicated in the table.

7. Install in the reverse order of removal.

8. Bleed the air from the system. Service and Repair

9. After installation, inspect the clutch pedal. Adjustments










Clutch Master Cylinder Removal Note

1. Rotate the clutch master cylinder in the direction shown and remove.






2. Press on the tabs on the left and right sides of the push rod using a flathead screwdriver and remove the rod.






Clutch Master Cylinder Installation Note

1. Push the push rod in until the tabs lock.






2. Rotate the clutch master cylinder in the direction shown until it stops.






Starter Interlock Switch Installation Note

1. Insert the new starter interlock switch into the pedal bracket hole in the direction indicated by arrow A.






2. Slide the starter interlock switch pressing it in the direction indicated by arrow B until it is locked.






3. Press the clutch pedal fully in the direction indicated by arrow C and adjust the starter interlock switch terminal.

Clutch Pedal Position Switch Installation Note

1. Insert the new clutch pedal position switch into the pedal bracket hole until the switch stops.






2. Rotate the clutch pedal position switch 45° clockwise.






3. Verify that the clutch pedal position switch is locked securely.