Shifter M/T: Service and Repair

MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [C66M-R]

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable. Removal and Replacement

3. Remove the shift lever.
a. Remove the upper panel. Upper Panel Removal/Installation

b. Remove the shift lever knob.






c. Remove the shift panel. Shift Panel Removal/Installation

d. Remove the side wall. Side Wall Removal/Installation

e. Remove the console. Console Removal/Installation

f. Detach the clip as shown in the figure.






g. Remove the control cable end from shift lever using a fastener remover.






h. Press the tabs on the control cable as shown in the figure and remove the shift lever from the control cable.






i. Remove the shift lever.






4. Remove the control cable.
a. Disconnect the drain hose connected to A/C unit.






b. Remove the control cable end from the MTX.
i. Pull the lock pin in the direction of the arrow shown in the figure and release the control cable end (MTX side) lock.






ii. Remove the control cable end from the MTX.

c. Press the tabs on the control cable and disconnect the control cable from the bracket.






d. Remove the bracket.






i. Remove the brace bar. Service and Repair

ii. Remove the fastener retaining insulator (front) and set insulator (front) aside. Service and Repair

iii. Remove the fastening nut for the bracket.

iv. Remove the fastening clip for the bracket and remove the bracket.

e. Remove the fastening nuts for the grommet.






f. Remove the control cable using two people.
i. While pressing the shift side of the control cable from the cabin, pull it out to the engine compartment.






ii. While pressing the select side of the control cable from the cabin, pull it out to the engine compartment.






5. Install the control cable using two people.
a. While pressing the select side of the control cable from the engine compartment, push it in to the cabin.






b. While pressing the shift side of the control cable from the engine compartment, push it in to the cabin.






6. Install the fastening nuts for the grommet.






Tightening torque
- 4.0-9.8 Nm {41-99 kgf-cm, 36-86 in-lbf}

7. Install the bracket.






a. Install the bracket and install the fastening clip to the bracket.

b. Install the fastening nut to the bracket.

Tightening torque
- 19-25 Nm {2.0-2.5 kgf-m, 15-18 ft-lbf}

c. Install the insulator (front).

d. Install the brace bar.

8. Connect the control cable to the bracket.






9. Install the control cable end to the MTX.
a. Press the lock pin in the direction of the arrow shown in the figure.






b. Install the control cable end to the MTX.
NOTE:
- When the connector is engaged, a click sound is heard.

10. Install in the reverse order of removal.