Rear Pillar Trim, Removal/Installation
Removal and installation of trim on rear pillarRemoval
1. Pull chafing strip in range of trim from rear pillar.
2. Disconnect the 3 front fastening hooks on trim in direction of vehicle center.
3. Pull trim forward and remove.
4. Unscrew belt end fitting on vehicle floor, removing rear seat cushion for this purpose.
5. Guide belt end fitting through opening in trim and remove trim.
Installation
6. Align holding clip on trim.
7. Guide belt end fitting through opening in trim and screw to vehicle floor.
8. Insert trim from the front with holding clamp into recess on rear pillar and clip on by means of the 3 front fastening hooks.
9. For further installation proceed vice versa.
B. T-sedan
Remove and install
1. Remove loading space trim at the left or open at the right.
2. Remove spare wheel.
3. Remove loading space lamp.
4. Remove trim below.
5. Unscrew screw at the top, pull trim in downward direction and remove.
6. Introduce trim with hook (arrows) into recess on rear pillar from below and fasten with screw at the top.
7. Connect loading space lamp and fasten with clips.
8. Lift rubber lip from rubber frame of side window pane above trim.
9. Fasten trim below above sheet metal fold and insert plastic clips (3 each).
10. For further installation proceed vice versa.