P0606

DTC P0606: Powertrain Control Module Main Processor Malfunction

TECHNICAL DESCRIPTION
- Throttle actuator control module processor checks the PCM for abnormal conditions

DESCRIPTIONS OF MONITOR METHODS
No watch dog pulse is detected

MONITOR EXECUTION
Continuous

MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)

Other Monitor (There is no temporary DTC stored in memory for the item monitored)
- Not applicable

Sensor (The sensor is determined to be normal)
- Not applicable

DTC SET CONDITIONS

Check Conditions
- Ignition switch is "ON" position

Judgement Criteria
- No surveillance pulse signals should be input for 0.5 second

OBD-II DRIVE CYCLE PATTERN
None

TROUBLESHOOTING HINTS (The most likely causes for this code to be set are:)
- PCM failed

DIAGNOSIS

Required Special Tools:
- MB991958: Scan tool (MUT-III Sub Assembly)
- MB991824: V.C.I
- MB991827: USB Cable
- MB991910: Main Harness A




STEP 1. Using scan tool MB991958, read the diagnostic trouble code (DTC).

CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK"(OFF) position before connecting or disconnecting scan tool MB991958.

1. Connect scan tool MB991958 to the data link connector.
2. Turn the ignition switch to the "ON" position.
3. After the DTC has been deleted, read the DTC again.
4. Turn the ignition switch to the "LOCK"(OFF) position.

Q: Is DTC P0606 set?

YES: Replace the PCM.

NO: It can be assumed that this malfunction is intermittent. Refer to How to Use Troubleshooting/Inspection Service Points.