Driver/Vehicle Information Display: Description and Operation

INTEGRATED DISPLAY SYSTEM

System Description

AV SWITCH SYSTEM

Refer to Owner's Manual for AV switch operating instructions.
Using the AV switch at the center of the instrument panel, the controls of the following systems are centralized:
- Integrated display system (Drive computer, setting screen, clock, etc.)
- Audio system

PRECAUTION OF LCD MONITOR
- Brightness of LED backlight display may change, depending on in-car temperature. In low temperatures, the refreshing rate of the picture also becomes low because of the low response of the LCD monitor.

When passenger area becomes warm, however, the LCD recovers the normal display.
- Backlight sometimes flickers or darkens according to the total operation hours and the number of times switched ON and OFF. In this case, entire display unit should be replaced. (Backlight cannot be replaced separately.)

POWER SUPPLY AND GROUND
Power is supplied at all times
- through 20 A fuse (No. 31, located in fuse and fusible link box)
- to audio unit terminal 6
- through 10 A fuse [No. 3, located in fuse block (J/B)]
- to display unit terminal 1 and
- to AV switch terminal 1.

When the ignition switch is in ACC or ON position, power is supplied
- through 10 A fuse [No. 6, located in fuse block (J/B)]
- to display unit terminal 2 and
- to AV switch terminal 2.

When the ignition switch is in ON or START position, power is supplied
- through 10 A fuse [No. 12, located in fuse block (J/B)]
- to unified meter and A/C amp. terminal 22 and
- to display unit terminal 3.

Ground is supplied
- to display unit terminal 6
- to AV switch terminal 5
- to unified meter and A/C amp. terminals 29 and 30
- through body grounds M57, M61 and M79.

DRIVE COMPUTER
Refer to Owner's Manual for drive computer operating instructions.

CAN COMMUNICATION SYSTEM DESCRIPTION
Refer to LAN-25, Information Bus. Information Bus