P0442

P0442 EVAP CONTROL SYSTEM

DTC Logic




DTC Detection Logic
This diagnosis detects leaks in the EVAP purge line using engine intake manifold vacuum.

If pressure does not increase, the ECM will check for leaks in the line between the fuel tank and EVAP canister purge volume control solenoid valve, under the following "Vacuum test" conditions.

The EVAP canister vent control valve is closed to shut the EVAP purge line off. The EVAP canister purge volume control solenoid valve will then be opened to depressurize the EVAP purge line using intake manifold vacuum. After this occurs, the EVAP canister purge volume control solenoid valve will be closed.

CAUTION:
- Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the MIL may come on.
- If the fuel filler cap is not tightened properly, the MIL may come on.
- Use only a genuine NISSAN rubber tube as a replacement.

Step 1-3:

DTC Confirmation Procedure

Step 1:

Step 1 (Continued)-7:

Step 7 (Continued)-12:

Step 12 (Continued)-21:

Step 21 (Continued)-22:

Diagnostic Procedure

Step 1-2:

Component Inspection