Brake Pedal Assy: Service and Repair

BRAKE PEDAL

BR-16 Exploded View:

NOTE: Clevis pin can be installed from both left and right.

Removal and Installation

REMOVAL
1. Remove instrument lower cover (LH) and lower knee protector.
2. Remove steering column assembly.
3. Disconnect stop lamp switch and ASCD switch connector.
4. Remove stop lamp switch and ASCD switch from brake pedal assembly.
5. Disconnect brake pedal stroke sensor connector (With pre-crash seat belt).

CAUTION: Brake pedal stroke sensor is not detachable. Do not detach it.

6. Remove snap pin and clevis pin from clevis of brake booster.
7. Remove brake pedal assembly nuts. Pull brake booster toward engine room to the extent that does not deform brake tube.
8. Remove brake booster clevis from input rod.
9. Remove bolt and then remove brake pedal assembly from vehicle.

INSTALLATION
Installation is in the reverse order of removal.
^ Tightening brake pedal assembly nuts and bolts to specified torque.
^ Adjust brake pedal height after installing brake pedal assembly to vehicle. Refer to BR-12, "Inspection and Adjustment". Testing and Inspection

CAUTION: Do not reuse clevis pin.