Memory Positioning Systems: Description and Operation

Schematic

Automatic Drive Positioner Schematic (Part 1):

Automatic Drive Positioner Schematic (Part 2):

System Description
- Refer to Owner's Manual for Automatic Drive Positioner system operating instructions.
- The settings (ON/OFF) of the automatic sliding seat (entry/exiting operation) at entry/exit can be changed desired, using the display unit in the center of the instrument panel. The set content is transmitted by CAN communication, from display control unit to driver seat control unit.
- Using CONSULT-III, the seat slide amount at entry/exit setting can be changed.






NOTE:
- Disconnecting the battery erases the stored memory.
- After connecting the battery, close the front door LH, push and hold the key switch and ignition knob switch and then operate the front door switch LH ON (open) OFF (close) ON (open) OFF (close), the entry/exiting operation becomes possible.
- After exiting operation is carried out, return operation can be operated.






NOTE: During automatic operation, if the ignition switch is turned ON START, the automatic operation is suspended. When the ignition switch returns to ON, it resumes.

Fail-Safe Mode
When the ignition switch is in the ON position, if any of the parts (indicated in the following chart) move more than the specified amount within a period "T1" when no "ON" input is sent from any of the switches (indicated in the following chart), or an output from the automatic drive positioner is not produced, an output malfunction is sensed. Motor operation will be suspended automatically, and all automatic operations will be ineffective. ( this case, the motor will not operate manually).






Cancel of Fail-safe Mode
- The mode is cancelled when the CVT selector lever is shifted to P position from any other position.