Removal And Installation

DOOR LOCK


FRONT DOOR LOCK : Removal and Installation


REMOVAL
1. Remove front door finisher. Refer to Removal and Installation.
2. Remove front door module assembly. Refer to Removal and Installation.





3. Disconnect door antenna and door request switch connector and remove harness clamp on outside handle bracket.
4. Remove door side grommet, and loosen TORX bolt from grommet hole.





5. Disconnect the key cylinder rod from the door key cylinder.
6. While pulling outside handle, remove door key cylinder assembly (driver side) or outside handle escutcheon (passenger side).





7. While pulling outside handle, slide toward rear of vehicle to remove outside handle.
8. Remove front gasket and rear gasket.





9. While pulling outside handle bracket, slide toward rear of vehicle to remove outside handle bracket.
10. Separate the outside handle cable connection from the outside handle bracket.





11. Remove door lock assembly TORX bolts.
12. Disconnect door lock actuator connector, and then remove door lock assembly.
13. Remove key rod from door lock assembly.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- When installing each rod, rotate rod holder until a click is felt.
- Check door open/close, lock/unlock operation after installation.