Inspection and Adjustment

BRAKE PEDAL


Inspection and Adjustment


INSPECTION





1. Inspect the brake pedal height (H) and brake pedal full stroke
(S) from the floor using Tool at a 90� angle to the floor.

Tool number : (J-46532)

2. Adjust the brake pedal height to specification.






ADJUSTMENT





1. Loosen stop lamp switch and ASCD switch (if equipped) by rotating it counterclockwise by 45�.
2. Loosen lock nut on input rod, then rotate input rod to set pedal to the specified height, and tighten lock nut.

CAUTION:
Make sure that the threaded end of input rod stays inside clevis.

Lock nut : Refer to Removal and Installation.

3. With the pedal pulled and held by hand, press stop lamp switch or ASCD switch (if equipped) until its threaded end contacts brake pedal lever.
4. With the threaded end of stop lamp switch or ASCD switch (if equipped) contacting brake pedal lever, rotate the switch clockwise by 45� to secure.

CAUTION:
Make sure that the clearance (C) is within the standard.
5. Start engine to check brake pedal full stroke.

CAUTION:
Make sure that stop lamps go off when brake pedal is released.