Receiver Dryer: Service and Repair

LIQUID TANK


Removal and Installation of Liquid Tank


REMOVAL
1. Remove the condenser. Service and Repair.
2. Clean liquid tank and its surrounding area, and remove dirt and rust from liquid tank.

CAUTION:
Be sure to clean carefully.
3. Disconnect the refrigerant pressure sensor electrical connector.

CAUTION:
Do not remove the refrigerant pressure sensor from the liquid tank. They are serviced as an assembly.





4. Remove bolts (A) and (B) from liquid tank (1).





5. Remove liquid tank bracket and refrigerant pressure sensor as an assembly. Discard the O-rings (2).
6. Slide liquid tank (3) upward, and then remove liquid tank (3).

INSTALLATION





Installation is in the reverse order of removal.

CAUTION:
- Make sure liquid tank bracket (2) is securely installed at protrusion of condenser (3). [Make sure liquid tank bracket (2) does not move to a position below center of liquid tank (1).]
- Replace O-rings for A/C piping with new ones, and apply compressor oil when installing.
- When recharging refrigerant, check for leaks. Checking Of Refrigerant Leaks, "Checking of Refrigerant Leaks".