Condenser HVAC: Service and Repair

CONDENSER


Removal and Installation for Condenser


REMOVAL
1. Discharge the refrigerant. HFC-134A (R-134A) Service Procedure.
2. Remove the front grille. Removal And Installation Sedan (Sedan), Removal And Installation Coupe (coupe). Removal And Installation Coupe
3. Remove the junction pipe. Junction Pipe Removal And Installation.

CAUTION:
Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of contaminants.
4. Disconnect the refrigerant pressure sensor connector.





5. Depress the top RH clip (A) and the top LH clip (B) to release the top condenser brackets as shown.
6. Slide the condenser up to release the condenser from the clips as shown.
7. Remove the condenser and liquid tank with refrigerant pressure sensor assembly.

CAUTION:
Do not damage the condenser fins

INSTALLATION
Installation is in the reverse order of removal. Component.

CAUTION:
- Do not damage the condenser fins.
- Replace the O-rings of the junction pipe and refrigerant pressure sensor with new ones, then apply
A/C oil to them after installing them.
- When charging refrigerant, check for leaks. Checking Of Refrigerant Leaks.