Condenser HVAC: Service and Repair

CONDENSER


CONDENSER : Removal and Installation for Condenser


REMOVAL
1. Discharge the refrigerant. Service and Repair.
2. Remove the RH hoodledge cover.
3. Remove the front bumper cover. Removal And Installation.
4. Remove the junction pipe. Condenser Pipe Assembly Removal And Installation.

CAUTION:
Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of contaminants.
5. Disconnect the refrigerant pressure sensor connector, if necessary remove the refrigerant pressure sensor.





6. Depress the top RH clip (A) and the top LH clip (B) to release the top condenser brackets as shown.
7. Slide the condenser up to release the condenser from the clips.
8. Remove the condenser.

CAUTION:
Do not damage the condenser fins

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- Do not damage the condenser fins.
- Replace the O-rings with new ones, then apply compressor oil to them for installation.
- When charging refrigerant, check for leaks. Checking Of Refrigerant Leaks.