Inspection and Adjustment

BRAKE PEDAL


Inspection and Adjustment


INSPECTION






1. Check brake pedal free height (H) from dash panel top surface using Tool.





2. Check clearance between pedal stopper and threaded end of stop lamp switch (C1) and ASCD cancel switch (C2), if equipped.






ADJUSTMENT





1. Loosen stop lamp switch and ASCD cancel switch, if equipped, by rotating it counterclockwise by 45�.
2. Loosen lock nut on input rod, then rotate input rod to set pedal to the specified height, and tighten the lock nut.

CAUTION:
Make sure that the threaded end of input rod stays inside clevis.






3. With the pedal pulled and held by hand, press stop lamp switch and ASCD cancel switch, if equipped, until their threaded end contacts the brake pedal stopper.
4. With the threaded end of stop lamp switch and ASCD cancel switch, if equipped, contacting brake pedal stopper, rotate the switches clockwise by 45� to secure.

CAUTION:
Make sure that the clearance (C) is within specification.
5. Check that the stop lamps go out when the brake pedal is released.

CAUTION:
Make sure that stop lamps go off when brake pedal is released.
6. Start the engine and check the brake pedal for smooth operation.