Front Passenger Air Bag Module

FRONT PASSENGER AIR BAG MODULE


Removal and Installation


REMOVAL

WARNING:
- When servicing the SRS, do not work from directly in front of air bag module.
- Always place front passenger air bag module with pad side facing upward.

CAUTION:
- Before servicing SRS, turn the ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
- Do not use old bolts after removal; replace with new bolts.
- Do not insert any foreign objects (screwdriver, etc.) into air bag module or harness connectors.
- Do not disassemble air bag module.
- Do not expose the front passenger air bag module to temperatures exceeding 90�C (194�F).





- Replace the front passenger air bag module if it has been dropped or sustained an impact.
- Do not allow oil, grease or water to come in contact with the front passenger air bag module.
1. Disconnect the negative and positive battery terminals, then wait at least three minutes.
2. Remove the side ventilator assembly (right). Component Parts.





Arrow Indicates Vehicle front

3. Disconnect front passenger air bag module connector (1) and remove the upper instrument panel assembly bolts (2).
4. Remove the front passenger air bag module bolts (3) from the steering member.





5. Release the pawls and remove the front passenger air bag module (1) from the upper instrument panel assembly (2).

INSTALLATION
Installation is in the reverse order of removal.
- After the work is completed, perform self-diagnosis to check that no malfunction is detected. Reading and Clearing Diagnostic Trouble Codes.