Shifter A/T: Adjustments

SHIFT CONTROL SYSTEM


Adjustment of A/T Position

Move shift selector from "P" position to "1" position. You should be able to feel the detents in each position. If the detents cannot be felt or if the position indicator is improperly aligned, the control cable needs adjustment.

CAUTION:
Make sure that parking brake is applied before adjustment.
1. Remove the air duct assembly. Removal And Installation.





2. Remove the control cable nut (A) and control cable (1) and place the manual lever (2) in the "P'"position.
3. Place shift selector in "P" position.
4. Hold control cable (1) at the end and pull it with a force of 9.8 N
(approximately 1 kg, 2.2 lb). Release the control cable and temporarily tighten control cable nut (A).
5. Tighten control cable nut (A) to the specified torque.






CAUTION:
Secure manual selector when tightening nut.
6. Move shift selector from "P" to "1" position again. Make sure that shift selector moves smoothly.
7. Check A/T position. Testing and Inspection.
8. Install air duct assembly. Removal And Installation.