Inspection and Adjustment

BRAKE PEDAL

Inspection and Adjustment


INSPECTION






1.Inspect the brake pedal height (H) from the floor using Tool at a
90� angle to the floor.
Tool number:-(J-46532)
2.Adjust the brake pedal height to specifications.
BR
Brake Pedal Specifications






ADJUSTMENT






1.Loosen the stop lamp switch and ASCD cancel switch by turning it counterclockwise by 45�
.
2.Loosen lock nut (A) on the input rod, then turn input rod to adjust the brake pedal height to specification, and tighten lock nut (A).
Lock nut torque: Exploded View

CAUTION:
Make sure the threaded end of input rod stays inside clevis.
3.With the pedal pulled up and held by hand, press the stop lamp switch and ASCD cancel switch until the threaded end contacts the stopper.
4.With the threaded end of the stop lamp switch and ASCD cancel switch contacting the bracket, rotate the switch clockwise by 45� to secure.

CAUTION:
Make sure that the clearance (C) between bracket and end of stop lamp switch and brake switch is within the standard.
Specifications.
5.Check the brake pedal for smooth operation.

CAUTION:
Make sure that stop lamps are off when the brake pedal is released.