Fog/Driving Lamp: Adjustments

FRONT FOG LAMP

Aiming Adjustment

The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. Before performing aiming adjustment, make sure of the following.
- Keep all tires inflated to correct pressure.
- Place vehicle on level ground.
- See that vehicle is unloaded (except for full levels of coolant, engine oil and fuel, and spare tire, jack, and tools). Have the driver or equivalent weight placed in driver seat.





- Adjust aiming in the vertical direction by turning the adjusting screw (A).
- When performing adjustment, if necessary, cover the headlamps and opposite fog lamp.
1.Position the screen.
NOTE:
- Stop the vehicle facing the screen.
- Place the screen on a plain road vertically.
2.Face the screen with the vehicle. Maintain 7.62 m (25.0 ft) between the front fog lamp center and the screen.
3.Start the engine. Turn the front fog lamp ON.

CAUTION:
Never cover the lens surface with tape, etc. The lens is made of resin.
NOTE:
- Aim each fog lamp individually and ensure other fog lamp beam pattern is blocked from screen.





4.Adjust the fog lamp upper illumination limit with the aiming adjustment screw so that the illumination stops at the cutoff line (H).
- Front fog lamp light distribution on the screen is as shown.

- (A) High illumination area.
- H Horizontal center line of front fog lamp / Cutoff line.
- V Vertical center line of fog lamp.