P0706

P0706 TRANSMISSION RANGE SENSOR A

DTC Logic


DTC DETECTION LOGIC






Position Pattern Table






DTC CONFIRMATION PROCEDURE


1. PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, power switch OFF and wait for at least
10 seconds, then perform the next test.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT
1.Set the vehicle to READY.
2.Select "Data Monitor" in "SHIFT".
3.Select "RANGE POSITION".
4.Shift the selector lever as follows. (Hold the selector lever at each position for 2 seconds or more.)
- H N R N D N H
5.Repeat step 4 five more times.
6.Check DTC.
Is "P0706" detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK ELECTRIC SHIFT SENSOR INPUT SIGNAL

With CONSULT
1.Set the vehicle to READY.
2.Select "Data Monitor" in "SHIFT".
3.Select "SHIFT SENSOR 1", "SHIFT SENSOR 2", "SHIFT SENSOR 3", "SHIFT SENSOR 4", "SHIFT SENSOR 5", and "SHIFT SENSOR 6".
4.Operate the selector lever to identify a electric shift sensor of which value does not change.






Without CONSULT
1.Set the vehicle to READY.
2.Operate the selector lever.
3.Check the voltage between electric shift control module vehicle side harness connector terminal and ground.





- GO TO 2.

2. CHECK HARNESS BETWEEN ELECTRIC SHIFT CONTROL MODULE AND ELECTRIC SHIFT SENSOR

1.Power switch OFF.
2.Disconnect the electric shift control module connector.
3.Disconnect the electric shift sensor connector.
4.Check the continuity between the malfunctioning electric shift sensor identified at Step 1 and the harness connector terminal located on the vehicle side of the electric shift control module.





5.Check the continuity electric shift control module vehicle side harness connector terminal and ground.





Is the inspection result normal?
YES- Replace the electric shift sensor. Refer to "Exploded View" Exploded View.
NO- Repair or replace damaged parts.