Camera: Adjustments

REAR VIEW CAMERA

Adjustment

If the side distance guiding lines are dislocated after installation of the rear view camera, adjust the position of the side distance guiding lines.





1.Draw the correction lines at the rear of the vehicle passing through the following points: 20 cm from both sides of the vehicle, and 0.5 m and 1.0 m from the rear end of the bumper.
2.Set "Adjust offset of rear view camera" mode in Confirmation/
Adjustment mode.





3.Operate the touch panel and select the guiding line pattern so that its angle is aligned with the correction line of the rear of the vehicle.

4.Press the upper/lower/left/right switch to perform the fine adjustment of the guiding lines so that the position of the guiding lines is aligned with the correction lines of the rear of the vehicle. The position of adjusted guiding line is recorded to the AV control unit by pressing the "Enter" switch.

CAUTION:
Never perform other operations while the guiding line position is memorized.