B2116

Description

- The tilt motor is installed to the steering column assembly.
- The tilt motor is activated with the automatic drive positioner control unit.
- The steering column is tilted up/down by changing the rotation direction tilt motor.


DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. STEP 1

Turn ignition switch ON.
- GO TO 2

2. STEP 2

Check "Self diagnostic result" with CONSULT.
Is the DTC detected?
YES- Perform diagnosis procedure. .
NO- Inspection End.


Diagnosis Procedure

Regarding Wiring Diagram information, [1][2]Electrical Diagrams.

1. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn ignition switch ON.
2.Check "Self diagnostic result" with CONSULT.
3.Erase the DTC.
4.Perform DTC confirmation procedure. .
Is the DTC displayed again?
YES- GO TO 2.
NO- Check intermittent incident. Intermittent Incident.

2. CHECK TILT MOTOR CIRCUIT (POWER SHORT)

1.Turn ignition switch OFF.
2.Disconnect automatic drive positioner control unit and tilt motor connector.
3.Check voltage between tilt motor harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace harness or connector.

3. CHECK AUTOMATIC DRIVER POSITIONER CONTROL UNIT OUTPUT SIGNAL

1.Connect automatic drive positioner control unit connector.
2.Check voltage between automatic drive positioner control unit harness connector and ground.





Is the inspection result normal?
YES- GO TO 4.
NO- Replace automatic drive positioner control unit. Service and Repair.

4. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
- INSPECTION END