B2605

Description

BCM confirms the shift position with the following 4 signals.
- CVT selector lever
- Transmission range switch
- P position signal from IPDM E/R (CAN)
- P position signal from TCM (CAN)


DTC Logic


DTC DETECTION LOGIC

NOTE:
- If DTC B2605 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
Security System.
- If DTC B2605 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to
Security System.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn ignition switch ON under the following conditions and wait for at least 1 second.
-CVT selector lever is in the P or N position
-Do not depress the brake pedal.
2.Check "Self diagnostic result" with CONSULT.
Is DTC detected?
YES- .
NO- Inspection End.


Diagnosis Procedure

Regarding Wiring Diagram information, Intelligent Key System/Engine Start Function or NVIS.

1. CHECK DTC WITH IPDM E/R

Check "Self diagnostic result" with CONSULT. Testing and Inspection.
Is the inspection result normal?
YES- GO TO 2
NO- Repair or replace malfunctioning parts.

2. CHECK TRANSMISSION RANGE SWITCH CIRCUIT

1.Turn ignition switch OFF.
2.Disconnect TCM harness connector and BCM harness connector.





3.Check continuity between TCM connector F15 (A) terminal 20
and BCM harness connector M18 (B) terminal 48.





4.Check continuity between TCM harness connector F15 (A) terminal 20 and ground.





Is the inspection result normal?
YES- GO TO 3
NO- Repair harness or connector.

3. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
- Inspection End.