Removal And Installation

TELESCOPIC MOTOR

Removal and Installation


REMOVAL

1.Remove instrument lower cover LH. Exploded View.





2.Remove knee bolster bolts (A) and the knee bolster (B).
3.Telescope the steering wheel to the full out position and tilt to highest position.
NOTE:
If either function is inoperative you can do this manually prior to installation.
4.Remove the steering column covers. Removal And Installation.
NOTE:
The tilt/telescope switch can remain attached to the side cover.





5.Remove telescope motor as follows.
1.Disconnect telescope motor electrical connector (A).
2.Remove the two telescope link screws (B) and link bracket.
3.Remove telescope bolt (C).
4.Remove the telescope motor (D).
NOTE:
If the steering wheel could not be telescoped to full out position manually pull steering wheel to the full out position.

INSTALLATION

Installation is in the reverse order of removal.
NOTE:
- Adjust the telescope link to full out position and adjust as needed to fit into proper installed position.
- Inform customer that they will need to reset their Automatic Drive Positioner (ADP) settings.