Hazard Warning Switch: Service and Repair
HAZARD WARNING SWITCH REPLACEMENT - ON VEHICLEREMOVAL PROCEDURE
1. Remove the center air louver deflector. Refer to Air Deflector Louver Replacement - Center Vent.
2. Remove the instrument panel cluster.
3. Remove the hazard warning switch bezel from the instrument panel using a small-flat bladed tool to release the retainers.
4. Remove the left side bolt from the hazard warning switch through the instrument panel cluster pocket.
5. Remove the right side and center lower bolts from the hazard warning switch through the center air louver deflector pocket.
6. Reposition the hazard warning switch from the instrument panel to access the electrical connector.
7. Disconnect the electrical connectors from the hazard warning switch.
8. Remove the hazard warning switch from instrument panel.
INSTALLATION PROCEDURE
1. Connect the electrical connectors to the hazard warning switch.
2. Position the hazard warning switch to the mounting points in the instrument panel.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the left side bolt to the hazard warning switch through the instrument panel cluster pocket.
Tighten
Tighten the left side hazard warning switch bolt to 3 N.m (27 lb in).
4. Install the right side and center lower bolts to the hazard warning switch through the center air louver deflector pocket.
Tighten
Tighten the left side hazard warning switch bolt to 3 N.m (27 lb in).
5. Install the hazard warning switch bezel to the instrument panel pressing into place until fully seated.
Install the instrument panel cluster.
6. Install the center air louver deflector. Refer to Air Deflector Louver Replacement - Center Vent.