Inside Rearview Mirror Replacement (DD7)

Inside Rearview Mirror Replacement (DD7)

Removal Procedure

Notice: Do not use tools or other objects to pry the mirror mount or the mirror away from the windshield. Using tools may damage the mirror mount, the mirror or the windshield.




1. Remove the electrical connectors (2) at the rear of the mirror assembly.
2. Twist the mirror to one side and use one hand to support the edge of the mirror against the windshield. Use the other hand to pull the mirror away from the windshield with a quick jerk.

Installation Procedure




1. Position the bottom of the mirror base (3) against the windshield at the top of the support.
2. Slide the base onto the support keeping the base parallel to the windshield.
3. As the base starts to engage, apply a force against the base while maintaining a downward force until it snaps onto the support with an audible click. This operation will require at least 89 Newtons (20 lb) of force.
4. Check to make sure the mirror is securely attached to the support by adjusting the mirror in a normal up/down and side to side range.




5. Install the electrical connector (2) into the electrical cavity in the back of the mirror (1). An audible click should be heard to indicate the proper installation of the connector.