Trim Panel Replacement - Front Seat

Trim Panel Replacement - Front Seat

Removal Procedure





1. Remove the front seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front (Seat Back Recliner Handle Replacement - Front).
2. Remove the screws from the seat cushion trim panel.
3. Remove the seat cushion trim panel.
Pull the seat cushion trim panel to release the two retaining clips located on each side the recliner handle hole.
4. Disconnect the power seat switches electrical connectors.
5. Remove the seat cushion trim panel from the seat.
6. Remove the six-way power seat switch, if required. Refer to Seat Switch Replacement - Power (Service and Repair).


Installation Procedure





1. Install the six-way power seat switch, if required. Refer to Seat Switch Replacement - Power (Service and Repair).
2. Connect the power seat switches electrical connectors.
3. Install the seat cushion trim panel, pressing in until the two retaining clips are fully seated.

Notice: Refer to Fastener Notice in Cautions and Notices.


4. Install the seat cushion trim panel screws.

Tighten the seat cushion trim panel screws to 3 N.m (27 lb in).

5. Install the front seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front (Seat Back Recliner Handle Replacement - Front).