Pressure Plate: Service and Repair

REMOVAL PROCEDURE





1. Remove the manual transmission.
2. Remove the pressure plate bolts (4).
3. Remove the pressure plate (3) and driven plate (2) from the dowel pins on the flywheel (1).

INSTALLATION PROCEDURE
^ Tools Required
- J 38836 Pilot Bushing Installer/Clutch Alignment Arbor





1. Install the clutch pressure and driven plate to the dowel pins on the flywheel.

IMPORTANT: When the clutch driven plate requires replacement, the engine flywheel must also be replaced along with the clutch pressure plate as an assembly.

2. Install the pressure plate bolts finger tight.
3. Install the J 38836 in order to align the clutch driven plate to the clutch pilot bearing.





4. Tighten the clutch pressure plate bolts.
^ Tighten the clutch pressure plate bolts (in sequence shown) to 70 Nm (52 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

5. Install the manual transmission.