Instrument Cluster / Carrier: Service and Repair

Instrument Cluster Replacement

Removal Procedure




1. Remove the instrument panel (I/P) cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement (Service and Repair).
2. Remove the I/P cluster screws.
3. Remove the I/P cluster.
4. Remove the I/P cluster wire harness connector.

Installation Procedure




1. Install the I/P cluster wire harness connector.
2. Install the I/P cluster.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Tighten the I/P cluster screws.

Tighten the screws to 2.5 Nm (22 lb in).

4. Install the I/P cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement (Service and Repair).
5. Refer to Control Module References (Programming and Relearning) for programming and setup information.