B1395

DTC B1395

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC B1395 02
- Device Voltage Reference Circuit short to ground

Diagnostic Fault Information





Circuit/System Description

S3 and S4 are part of the Rear Compartment Lid Release switch. The folding top control (FTC) module uses S3 and S4 to determine whether the claws at the rear of the deck lid are latched into the deck lid or unlatched. S3 closes and supplies a 12-volt reference to the signal circuit when the claws are unlatched. S4 closes and supplies a 12-volt reference to the signal circuit when the claws are latched.

Conditions for Running the DTC

The FTC module is active.

Conditions for Setting the DTC

A short to ground is detected on the 12-volt reference or signal circuits of S3 and S4.

Action Taken When the DTC Sets

The top is disabled.

Conditions for Clearing the DTC

The fault is no longer present and the top completes one cycle.

Diagnostic Aids

A short to B+ may damage S3 or S4.

Reference Information
Schematic Reference

Folding Top Schematics ([1][2]Convertible Top)
Connector End View Reference

Component Connector End Views (Connector Views)
Description and Operation

Power Folding Top Description and Operation (Power Folding Top Description and Operation)
Electrical Information Reference

* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)

Scan Tool Reference

Control Module References (Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the X2 harness connector at the FTC Module.
2. Ignition ON, verify a test lamp does not illuminate between the signal circuit terminal 12 and B+.

• If the test lamp illuminates, test the signal circuit for a short to ground.

3. Verify a test lamp does not illuminate between the signal circuit terminal 24 and B+.

• If the test lamp illuminates, test the signal circuit for a short to ground.

4. Remove the Rear Compartment Lid Release Switch.
5. Test for infinite resistance between terminal C and terminal A.

• If less than the specified value, replace the Rear Compartment Lid Release switch.

6. Test for infinite resistance between terminal C and terminal B.

• If less than the specified value, replace the Rear Compartment Lid Release switch.

7. If all circuits test normal, replace the FTC module.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Folding Top Control Module Replacement (Service and Repair)