Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement (Rear Indicator Bulb)

Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement (Rear Indicator Bulb)

Removal Procedure

Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).

1. Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Service and Repair).
2. Open the rear compartment lid.
3. Remove the rear compartment carpet.




4. Remove the four convenience net retaining hooks (1).





Note: Pull the end panel (1) upwards to disengage the end panel retaining pins.

5. Remove the end panel (1) from the vehicle (2).




6. Remove the rear compartment lining clip and pull back the lining for access to the rear bulbs.




7. Remove the rear indicator light bulb (1) and socket (2) from the rear tail lamp assembly by rotating the socket counter-clockwise.
8. Remove the rear indicator light bulb (1) from the socket (2) by pushing and rotating the bulb counter-clockwise.

Installation Procedure

1. Install the new rear indicator light bulb into the socket by pushing and rotating the bulb clockwise.





Note: The different sized tabs on the bulb base and mating cut-outs in the tail lamp assembly allow the bulb to seat correctly.

2. Install the rear indicator light bulb (1) and socket (2) into the rear tail lamp assembly and secure by rotating the socket clockwise.
3. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Service and Repair).
4. Check all vehicle lights for correct operation.




5. Install the rear compartment lining and reinstall the clip to secure the lining.




6. Install the end panel (1) to the vehicle (2) and listen for an audible click to confirm correct fitment.




7. Install the four convenience net retaining hooks (1).