Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement (Tail Lamp Assembly)

Tail Lamp Assembly and /or Backup, Sidemarker, Stop, Turn Signal Bulb Replacement (Tail Lamp Assembly)

Removal Procedure

Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).

1. Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Service and Repair).
2. Open the rear compartment lid.
3. Remove the rear compartment carpet.




4. Remove the four convenience net retaining hooks (1).





Note: Pull the end panel (1) upwards to disengage the end panel retaining pins.

5. Remove the end panel (1) from the vehicle (2).




6. Remove the rear compartment lining clip and pull back the lining for access to the rear tail lamp assembly.




7. Disconnect the rear tail lamp electrical connector (2).
8. Remove the rear tail lamp to rear end panel retaining nuts (1).




9. Remove the rear tail lamp assembly from the vehicle.

Installation Procedure





Note: Make sure the rear tail lamp sealing surface is clean to avoid damage to painted vehicle surfaces and to prevent water leaks.

1. Install the rear tail lamp assembly to the vehicle.





Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the rear tail lamp to rear end panel retaining nuts (1) and tighten to 3.00 Nm (27 lb in).
3. Connect the rear tail lamp assembly electrical connector (2).
4. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (Service and Repair).
5. Check all lights for the correct operation.




6. Install the rear compartment lining clip and pull back the lining for access to the rear tail lamp assembly.




7. Install the end panel (1) to the vehicle (2) and listen for an audible click to confirm correct fitment.




8. Install the four convenience net retaining hooks (1).