Test Point 6

Test point 6

Supply voltage
(5 volts)

Voltage too high
Voltage too low
Fault code 25

Diagnosis conditions

No control module fault stored.

Voltage too high

1. Unplug connector C from the heating/air-conditioning control.

2. Connect voltmeter to C 8 and ground.
Switch on ignition.
Display: 0 volts

If the battery voltage is displayed, check the wiring harness for pinching and chafing damage.

3. Push on connector C.

4. Connect voltmeter to C 8 and ground.
Switch on ignition.
Display: 5 plus or minus 0.5 volts

If more than 5.5 volts are displayed, replace the heating/air-conditioning control.

Voltage too low

1. Unplug connector C from the heating/air-conditioning control.

2. Unplug all connectors from the valve drive motors.

3. Connect ohmmeter to connector C 8 and ground.
Display: Infinite Ohms

If 0 - 5 Ohms is displayed, check wiring harness for pinching and chafing damage.

4. Check potentiometer in the drive motors.

Temperature mixing valve:
Connect ohmmeter to pins 1 and 3.
Display: 4 - 5 k Ohms at 23 �C

Footwell / defrost valve:
Connect ohmmeter to pins 1 and 3.
Display: 4 - 5 k Ohms at 23 �C

Central valve:
Connect ohmmeter to pins 1 and 3.
Display: 4 - 5 k Ohms at 23 �C

Outside air / recirculation valve:
Connect ohmmeter to pins 4 and 5.
Display: 4 - 5 k Ohms at 23 �C